|
|
| Vapheio cup. Flat base, lower body almost cylindrical, upper body is rounded and flaring, vertical tapered lip. One vertical handle attached at rim and 1/3 of way down body. Rim is slightly pressed inward ... based on shape, but could be LH I because of unslipped interior |
| Vapheio cup. Flat base, lower body cylindrical but flares slightly to ridge at mid-body, upper body flaring to tapered slightly outturned lip. One vertical handle attached at rim and above ridge. FS 224 ... based on form and decoration |
| Cup with flat bottom, body contracting slightly then flaring with nearly straight profile to rounded lip. Vertical strap handle attached from upper body to lip. FS 224 type 3 Dull red-brown paint: bottom: ... 1916/06/26
1916/06/26 |
| Cup of Vaphio shape (FS 224). Flat base. Lower part of body almost cylindrical, upper part conical. Vertical rim. One vertical strap handle attached at rim and body, ca. 1/3 of way down. No ridge in the ... 1916/06/26
1916/06/24 |
| Goblet. Short stem to rounded flaring lip. One vertical strap handle. FS 254 Exterior and interior are slipped Hard clay Fragment. 1 fragment preserves 1/2 of foot, 85% of body, 80% of rim, one lower handle ... LH IIA or B, same shape as Ephyraean goblet |
| Conical cup. Flat base with traces of wheel marks, finger prints and a small dab of extra clay. Body risesi n a continuous curve to vertical lip. FS 204 Undecorated Hard green buff clay Complete or intact ... FS dates to LH I-LH IIIA |
| Semi-globular cup. Flat slightly raised base, globular body to outward flaring lip. One small thin vertical strap handle from rim to midbody. FS 215, similar to MDP fig 183 no. 1 Exterior slipped and polished ... Or transitional LH IIIB-C early according to Rutter 1974, p. 412 |
| Deep bowl group A (FS 285) with vertical ring foot, flat undersurface, flat resting surface, pared exterior face of foot, ovoid body with maximum diameter above the median of the body, becomes vertical ... Based on Rutter 1974 and RMDP. |
| Based Askos. Shallow ring base, globular body with rounded shoulder. One vertical flattened handle attached at center of rim of pot and slightly down shoulder. Spout hole on axis of handle. FS 195 Exterior ... LH IIIB, based on Rutter 1974 |
| Small cup. Tiny crudely made ring base. Tall offset rim. One small vertical strap handle from rim of top of body. Buff slip. Decoration in brown and purple paint, lustrous (brown paint originally black) ... 1916/07/08 |
| Small aryballos. Slightly flattened base, globular body, thin small neck, large flat rim which overhangs neck. Tiny mouth. One tiny vertical strap handle from rim to sholder. Gray buff slip. Decoration ... Archaic? |
| Bowl or saucer with incurved rim. Ring base, conical body, rounded inturned lip. Fine hard clay Complete profile. 4 joining fragments preserve 1/2 of base, 1/2 of body, 1/2 of rim HM "E.A. XIX" in pencil ... EH II - in Lerna vol. IV p. 599 as a parallel to a Lerna III type 2 saucer |
| Bowl or saucer with incurved rim. Tiny "ring base", conical body, large rounded inturned lip. Semi-coarse gritty clay Complete profile. 7 joining fragments preserve all of base, 95% of body and rim HM ... EH II - similar to Lerna III type 2 saucer (Lerna Vol. IV.II, p. 596) |
| Bowl or saucer with incurved rim. Small ring base, conical body, rounded vertical lip. Very uneven lip. Griity clay, semi-fine Complete profile. 3 joining fragments preserve all of base, all of body, ... EH II?, based on context? |
| Bowl or saucer with slightly incurved rim. Crude flat base, conical body, rounded slightly inturning lip. Exterior polished. Coarse gritty clay Complete profile. 9 joining fragments preserve 3/4 of base, ... based on context? |
| Goblet. Flaring foot hollowed in center, short stem convex body, short flaring lip. One vertical strap handle from rim to widest diameter. Rim slightly pushed in where handle attached. FS 254, sim to MDP ... date based on similarity to MDP fig. 35 no. 1 |
| Goblet with false ring foot with vertical profile, pared on undersurface to simulate ring foot. Straight flaring body to carination at H00.06-00.068, narrow inturned shoulder, flaring rim with slight convex ... Middle Helladic |
| Small Grey Minyan cup or bowl. Flat base, carinated body largest at midpoint of body, tapered flaring lip. Handles attached at rim and midpoint of body. Medium fine clay, somewhat gritty Complete profile ... 1916/07/03 |
| Grey Minyan Bowl. Flat base, globular body, high tapered flaring lip. Short wide vertical strap handle from below rim to 1/3of way down body (probably two originally). Handle almost have a groove down ... 1916/07/11 |
| Beaked jug. Flat base, globular body with sloping shoulder and slightly flaring neck. Inside can see where neck added on to body it is lumpy - obviously clay for neck added and smoothed on already thrown ... 1916/06/27 |
| Breasted jug. Wide body. Shoulder under spout has small breast-like protrusions. Spout probably cutaway. One vertical strap handle from back of spout to maximum diameter of body. Buck (Hesp. 1964) shape ... based on Davis 1979 |
| Sauceboat. Small ring base, deep hemispherical body. Short spout rises slightly. One horizontal handle attached at back, triangular in section. Exterior painted with Urfirnis, except the bottom of base ... EH II - reference in Lerna vol. IV.II, p.586 to this vessel as a Type 1 sauceboat (Lerna III phase A or B) |
| Tankard. Ovoid body reaches max. diameter just above base, body tapers to large outturned lip. Large vertical strap handle attached at point of max. diameter. Exterior slipped and painted. Lower set of ... EH III - Lerna IV shape III.2 (medium); Lerna vol. III p. 286 |
| Squat Alabastron. Large flat base, squat rounded body, very low narrow neck with outturned rum. Three round horizontal handles (two remain) attahcd on sloping shoulder. FS 83 Exterior slipped and painted ... based on motif and shape |
| Small jug or jar. Flat base, globular budy. Fairly tall neck; flaring rim; flattened on top. No handle Thick creamy buff slip. Decoration in fine, lustrous brown paint. Neck and rim coated inside and out ... 1916/09/23 |
| Ring handled cup. Small shallow ring base. Shallow convex body to horizontal rim. FS 237 Exterior slipped and painted. Band at rim. Interior slipped and painted. Base has two concentric circles then a ... shape dates to LH I-LH IIIA, motif LH IIB-LH IIIA |
| Saucer. Slightly flattened base, shallow spreading body, slightly outturned rim, almost horizontal. FS 237? (but no base) Exterior slipped and painted. Band around base, traces of a curved vertical stripe ... based on context |
| Conical cup. Large flat base, conical body, vertical lip. Very uneven rim. FS 204 Slight groove on outside just below lip. Fine hard clay Complete profile. 5 joining fragments preserve all of base, 80% ... based on shape |
| Semiglobular cup. Slightly raised flat base, semi-globular body rises to rounded flaring lip. FS 212 Exterior slipped and painted. Base and part of lower body painted solid. One band at midbody below decorative ... 1916/06/23
1916/06/23 |
| Large Jug. Globular body, orunded shoulder, short narrow flaring neck with outturned lip. One large strap handle attached from rim to max. diameter. FS 109 Exterior slipped. Handle has slight grooves along ... based on Furumark |
| Minyan Bowl. Flat base, slightly raised, slightly flaring; body ovoid; small smightly offset rim; Two horizontal pierced lug handles attached at point of maximum diameter. Surface is slipped and burnished ... 1916 |
| Stirrup Jar. Globular body, rounded shoulder, small tube-like spout. Narrow vertical oval strap handle and false spout. FS 167 or 173. Exterior slipped and painted. On upper body, a pair of thick bands ... advanced LH IIIB or early LH IIIC (Rutter 1974 p. 378) |
| Jug (FS 65). Flat base, slightly concave, globular body, tall outturned lip. One broad vertical strap handle from rim to widest diameter. Exterior smoothed. Coarse, gritty clay with numerous large inclusions ... LH IIIC, based on Rutter |
| Strainer. Flat base pierced with fourteen holes, roughly cylindrical body, straight lip. Heavy round horizontal loop handle attached to one side of lip. Very gritty coarse clay Complete or intact. Intact ... based on context |
| Goblet with wide flaring foot with projecting ridge around upper circumference; short narrow stem, slightly hollowed; body with plump ovoid profile, max. diam. at 00.10; narrow straight flaring rim, round ... LH I, based on Furumark |
| Semiglobular cup. Small flat disk base slightly concave. Globular body, slightly flaring lip. One vertical round strap handle from rim to midpoint of body. FS-212. Exterior slipped and painted. One thick ... LH IIA-B, based on motif and shape |
| Ladle. Hemispherical body, small outturned lip. One very high swung ribbon handle from rim to widest diameter. Exterior is slipped. Fine clay Complete profile. three joining fragments preserve2/3 base, ... 1916/06/27
1916/06/29 |
| Ladle. Globular body rises to small outturned lip. One vertical strap handle. Exterior is slipped. Hard fine clay Fragment. three joining fragments preserve 1/2 body, 3/4 rim HM "EA X" in pencil on vessel ... 1916/06/29
1916/06/27 |
| Ladle. Globular body rises to outturned lip. One vertical, extremely high swung, strap handle from rim to widest diameter. Handle narrows towards base. Fine clay Fragment. four joining fragments preserve ... 1916/06/27
1916/06/29 |
| Goblet. Flat spreading foot, slightly hollowed underneath, short solid stem, hemispherical body, small outturned lip. One vertical strap handle attached at rim (and probably body). FS 263 or 254 (Ephyraean ... 1916/06/27
1916/06/29 |
|
|
