[Agora Object] A 3313: Cornice Fragment

Broken all around except top and bottom. From Square Peristyle. Poros of Akti; fair work. Traces of fire (?). Imbedded in the foundation of the eastern of the two N.-S. walls in the west part of the Heliaia, ... 18 August 1961

icon

[Agora Object] A 3386: Frieze Block: Doric

Block apparently complete. Only the right end has been exposed; in its upper half the end was left rough and its front edge chamfered to take the overlapping next frieze block (?); the lower half is cut ... 18 July 1963

icon

[Agora Object] A 3387: Frieze Block: Doric

Block now rests upside down so its original top is not visible. Both ends of block treated like right end of A 3386, i.e. rough in upper half and chamfered at front, square cut in lower half. Back of block ... 18 July 1963

icon

[Agora Object] A 3399: Cornice Block with Mason's Mark: Doric

Top is flat with a vertical step between a lower front and a higher back part. Cyma reversa bed mold, hawk's beak crown. Cutting for two Π-clamps at each end. In each end a cutting for an end dowel, which ... 28 May 1964

icon

[Agora Object] A 3400: Cornice Block

Corona has been cut away and the back part of the block reused as a water channel, the channel cut in the original underside. Preserved length of the block is probably very close to original. From Square ... 29 May 1964

[Agora Object] A 3500: Molding Fragment

Hawk's beak from epistyle of Square Peristyle. Coarse limestone darkened by fire (?). From same series as A 2922; cf. also A 2925. Found 18.00m. from east end of South Stoa II, behind foundation of colonnade ... 22 May 1965

icon

[Agora Object] A 3569: Frieze Block

Both ends and top cut away. Block comprised three triglyphs and two metopes with a triglyph in the middle. Both ends and top cut away. The block rested on a raised bearing surface in its middle above the ... 6 July 1966

icon

[Agora Object] A 3570: Frieze Block

Top and one end cut away, one end broken. Back rough finished with long vertical chisel strokes of a single point. Undercutting in middle of back for a shift bar. Metope faces finished with toothed chisel; ... 6 July 1966