|
|
| Well preserved except for corner of lower torus, which is broken away.
Corner block as A 3732 with same features. Upper surface has one lewis hole and a shallow cutting for a dovetail clamp on the return ... 24 July 1969 |
| Fillet and lower toros and face of plinth all broken away. Like A 3732 but from straight course rather than corner. Upper surface preserves lewis hole. Dowel hole without pour channel, and cutting for ... 24 July 1969 |
| Plinth, lower toros and square fillet broken away on right half of block. Like A 3732 but from straight course. On upper surface are cuttings for Π-clamps at both ends and what appear to be three dowel ... 24 July 1969 |
| Plinth, lower toros, and square fillet broken for left one-third of the block and block is cracked through behind this. Like A 3732 but from straight course. Upper surface preserves cutting for Π-clamps ... 24 July 1969 |
| Upper left corner is broken off but joining fragment survives. Like A 3732 but from straight course. On upper surface are cutting for Π-clamp on right, lewis hole in center, and dowel (?) hole on left ... 24 July 1969 |
| Three joining fragments only, the left of which preserves the full molding face. Upper left corner of this piece broken away. Like A 3732 but from straight course. On upper surface are three dowel cuttings ... 24 July 1969 |
| Right side broken off. Like A 3732. Upper surface preserves dowel hole without pour channel and cutting for Π-clamp. Right corner of back is cut in roughly 0.15m. from rear surface on left. Anathyrosis ... 24 July 1969 |
| Chipped; upper back right corner broken away. Above and right side worked with small toothed chisel, the same on the left side but an anathyrosis is left here. Back and below left rough. At left edge, ... 17 April 1951 |
|
|
